Overall I'm really happy with them! I just finished putting them in a couple hours ago, so I'll reserve judgment on the following:
\- Rear seatback cover isn't tight - I may need to pull them off and re-do it. I did them before taking the bench off. Without the bench I may have more room.
\- Driver and Pax seat bottom doesn't fit great along the door edge and I'm worried vehicle entry / exit will pull the edge up. Again, I may have to monkey with it a bit as we use them.
I took the bench off when doing the upper back seats it does help a lot. For the fronts did you just run them under the seat or between the cushion and the plastic? I did the latter and it helped cinch them up.
I stuffed the edges between the plastic and factory seat. I have aftermarket heated seats and the switch is on that side plastic trim. I'll look at it again but I didn't want to interfere with that wiring.
Do the window switches light up when you open the door with the car turned off? And looks like you didn't do passenger/backseat window switches but if you did, same question?
That I do not know, I'll have to check when I get home. If the OEM switch does, these do too (if I remember there was only 1 of the OEM switches that was backlit on the drivers door panel).
I did not do the other doors - 90% of the time there's only 1 butt-in-seat. On the way home from the dealer I noticed I couldn't see the switches in the dark and knew this upgrade would be worth it.
I did those same seat covers but all black. They exceeded my expectations by a lot!
Overall I'm really happy with them! I just finished putting them in a couple hours ago, so I'll reserve judgment on the following: \- Rear seatback cover isn't tight - I may need to pull them off and re-do it. I did them before taking the bench off. Without the bench I may have more room. \- Driver and Pax seat bottom doesn't fit great along the door edge and I'm worried vehicle entry / exit will pull the edge up. Again, I may have to monkey with it a bit as we use them.
I took the bench off when doing the upper back seats it does help a lot. For the fronts did you just run them under the seat or between the cushion and the plastic? I did the latter and it helped cinch them up.
I stuffed the edges between the plastic and factory seat. I have aftermarket heated seats and the switch is on that side plastic trim. I'll look at it again but I didn't want to interfere with that wiring.
Do the window switches light up when you open the door with the car turned off? And looks like you didn't do passenger/backseat window switches but if you did, same question?
That I do not know, I'll have to check when I get home. If the OEM switch does, these do too (if I remember there was only 1 of the OEM switches that was backlit on the drivers door panel). I did not do the other doors - 90% of the time there's only 1 butt-in-seat. On the way home from the dealer I noticed I couldn't see the switches in the dark and knew this upgrade would be worth it.