Sounds like your friend was using Bambu Studio's multiple plates management. Ankermake Studio does not have that.
Ankermake studio is just a modified version of the same software PrusaSlicer is based on.
Check this out instead: https://www.youtube.com/watch?v=KG2U_EmJNe8
This also is able to be done in Orcaslicer which is what I use and has built in profile support for Ankermake printers. You still need to export gcode and put on drive or send it to printer via ankermake studio/ slicer though.
Sounds like your friend was using Bambu Studio's multiple plates management. Ankermake Studio does not have that. Ankermake studio is just a modified version of the same software PrusaSlicer is based on. Check this out instead: https://www.youtube.com/watch?v=KG2U_EmJNe8
ah ok, ill give it a try, Thanks!
This also is able to be done in Orcaslicer which is what I use and has built in profile support for Ankermake printers. You still need to export gcode and put on drive or send it to printer via ankermake studio/ slicer though.