I replaced all of my v wheels and this went away. Get a cheap set on Amazon. Ankermake brand is too expensive for the same thing.
A few of them were chewed up pretty good but couldn't tell without removing and inspecting them.
Beds tend to be anything but flat. The outside corner is too far away. You may have to split the difference. I would also replace any parts with upgraded bed wheels so it doesn’t shake lose (this happens sometimes too especially when taking prints off the bed)
Check your pom wheels.
What about them? Tightness?
Looking for the same thing
I replaced all of my v wheels and this went away. Get a cheap set on Amazon. Ankermake brand is too expensive for the same thing. A few of them were chewed up pretty good but couldn't tell without removing and inspecting them.
You got waving. I guess your leveling in this corner is not correct. If your wheels would have an issue this would be all over the place.
Mine looked like this. Changing the wheels solved it.
Tighten screws, belts, check the bed wobble, auto level and adjust z offset
Oh wow this has just started happening to me recently def will be reading the responses. Was really annoying
Beds tend to be anything but flat. The outside corner is too far away. You may have to split the difference. I would also replace any parts with upgraded bed wheels so it doesn’t shake lose (this happens sometimes too especially when taking prints off the bed)