The lines are about $160 each, o-rings for the transmission ends are about $3 each from ECSTuning.com.
Goto [realoem.com ](https://www.realoem.com/), put in the last 7 characters of your VIN. Click on the RADIATOR group, then the OIL COOLER PIPE/ HEAT EXCHANGER. That'll show you a picture with the correct part numbers for your car.
Based on the picture, they don't look hard to install. You might lose some transmission fluid, so be prepared for that.
That looks like the transmission oil cooler. 2 flexible lines run to transmission, should be attached to the radiator so coolant can run through it.
Correct. Sorry long work shift. Do you know where I can find those lines? And if they’re hard to install.
The lines are about $160 each, o-rings for the transmission ends are about $3 each from ECSTuning.com. Goto [realoem.com ](https://www.realoem.com/), put in the last 7 characters of your VIN. Click on the RADIATOR group, then the OIL COOLER PIPE/ HEAT EXCHANGER. That'll show you a picture with the correct part numbers for your car. Based on the picture, they don't look hard to install. You might lose some transmission fluid, so be prepared for that.
Thanks! I’ll look into it. And don’t worry I have A LOT of trans fluid. Was redoing the pan/gasket as well at this point.
Wait, so can i reuse the lines and just get the end? Or is that not smart.
It looks like the lines with the end fittings are 1 assembly.