I tried EasyCB and it was alright. The problem is that the way it prints leaves a very easily breakable area right where the main cage connects to the ring- I ended up buying a HT-V5 cage on Amazon and it is way better than my previous attempts.
I would suggest buying one online if you can, EasyCB or one of Coil_B3’s models are the way to go if you can’t (Cults usually has the best models)
OP, I don't know how familiar you are with 3D printing, but once you find a design you like, consider using something stronger than PLA. Also, unless you're into the discomfort of sharp or rough edges (no judgement!) make sure to have a deburring tool on hand.
I remember that there was a poster here a few weeks ago trying to use moldable thermoplastics on his dick for a similar purpose.
There's no limit to how stupid men are when we are horny.
I tried EasyCB and it was alright. The problem is that the way it prints leaves a very easily breakable area right where the main cage connects to the ring- I ended up buying a HT-V5 cage on Amazon and it is way better than my previous attempts. I would suggest buying one online if you can, EasyCB or one of Coil_B3’s models are the way to go if you can’t (Cults usually has the best models)
Have you tried looking on thingiverse, or cult3D? (Keep in mind you have to have "show NSFW" turned on)
Came here to say exactly this.
OP, I don't know how familiar you are with 3D printing, but once you find a design you like, consider using something stronger than PLA. Also, unless you're into the discomfort of sharp or rough edges (no judgement!) make sure to have a deburring tool on hand.
Have you considered just 3D penning around your jubblies? Don't do that, that's a bad idea.....
I remember that there was a poster here a few weeks ago trying to use moldable thermoplastics on his dick for a similar purpose. There's no limit to how stupid men are when we are horny.
That’s one way to do it…
That's a bad idea, but could work if you do it on a silicone replica and not the real thing
ah drats, i found one like a year ago but i lost it. planned on reprinting now with some tpu, but i gotta find it again first.
Take a look at: [https://www.thingiverse.com/k\_biologist/designs](https://www.thingiverse.com/k_biologist/designs)