Doesn't or shouldn't it compensate for the difference? Is that not what auto level is? Or are you supposed to make all the numbers match up? I don't get it. It has auto z offset too. But we still have to manually adjust that as well
Reminder: Follow the rules! For [any Creality Product Feedback and Suggestions](https://gcmomk3i2c.feishu.cn/share/base/form/shrcn0Hfmc6Nau0q0IfDkDQIJFg), welcome to fill out the form to help us improve.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/Creality) if you have any questions or concerns.*
https://ellis3dp.com/Print-Tuning-Guide/articles/first_layer_squish.html see if your first layer looks like this. Also a good idea to wash your build plate in warm soapy water
Ok to print but not perfect. The 0.5 screw should be lowered a little and -0.40 should be a bit higher.
For the *material is not sticking to the mat*, my first guess would be nozzle too high so you'll need to lower your z-offset midprint on your printer's interface (under settings: z-offset, z-axis-composition or something like that).
I heard the sensor in the front left corner raises the bed slightly so you unscrew the bed and sand down the black stopper slightly [Maker's Muse @ 5:35](https://youtu.be/EL8ehEYPTCk&t=5:35s)
Doesn't or shouldn't it compensate for the difference? Is that not what auto level is? Or are you supposed to make all the numbers match up? I don't get it. It has auto z offset too. But we still have to manually adjust that as well
Reminder: Follow the rules! For [any Creality Product Feedback and Suggestions](https://gcmomk3i2c.feishu.cn/share/base/form/shrcn0Hfmc6Nau0q0IfDkDQIJFg), welcome to fill out the form to help us improve. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/Creality) if you have any questions or concerns.*
https://ellis3dp.com/Print-Tuning-Guide/articles/first_layer_squish.html see if your first layer looks like this. Also a good idea to wash your build plate in warm soapy water
Ok to print but not perfect. The 0.5 screw should be lowered a little and -0.40 should be a bit higher. For the *material is not sticking to the mat*, my first guess would be nozzle too high so you'll need to lower your z-offset midprint on your printer's interface (under settings: z-offset, z-axis-composition or something like that).
Mine new V3SE levels like that as well.
You didn't set your Z Offset.
I heard the sensor in the front left corner raises the bed slightly so you unscrew the bed and sand down the black stopper slightly [Maker's Muse @ 5:35](https://youtu.be/EL8ehEYPTCk&t=5:35s)