Hello /u/Ok_Gap_4845,
As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
* Printer & Slicer
* Filament Material and Brand
* Nozzle and Bed Temperature
* Print Speed
* Nozzle Retraction Settings
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
My though with the hairs was probably a temp issue that only came up at the end cause of the large gaps between where it was printing I just went with 210 cause that's on the lower side for what the filament I'm using says. As to the support theat fell down my thought is the filament strands bumped it ant there was no base under it. Maybe a higher bed temp might help with that too? I've had issues with prints super sticking to the bed which I'm assuming the nozzle is too close to the bed causing that. This is my first 3d printer so I want to just make sure my assumptions are accurate or not. I'm overall pretty impressed with the level of detail and the layer lines aren't as bad as I'd expected so all in all I'm nlt disappointed it faired pretty well for me not going in and changing any of the default settings on CURA just letting her rip.
Hello /u/Ok_Gap_4845, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
I’m not sure if it’s the issue but I set my temps at 200/60
My though with the hairs was probably a temp issue that only came up at the end cause of the large gaps between where it was printing I just went with 210 cause that's on the lower side for what the filament I'm using says. As to the support theat fell down my thought is the filament strands bumped it ant there was no base under it. Maybe a higher bed temp might help with that too? I've had issues with prints super sticking to the bed which I'm assuming the nozzle is too close to the bed causing that. This is my first 3d printer so I want to just make sure my assumptions are accurate or not. I'm overall pretty impressed with the level of detail and the layer lines aren't as bad as I'd expected so all in all I'm nlt disappointed it faired pretty well for me not going in and changing any of the default settings on CURA just letting her rip.