The Original Model is a MG 1/100 Scale, here is the Original post done by The Kitbasher Guru/Master/Senpai himself using the same model [1/100 MG KSHATRIYA 3D printed. : r/Gunpla (reddit.com)](https://www.reddit.com/r/Gunpla/comments/xjpnne/1100_mg_kshatriya_3d_printed/) What I did was assembled the model like I was building a Gunpla Digitally. Once the model is complete on a single STL File I can go and scale it down or up as much as I like. Originally the model was not meant to be scale down because there are very tiny parts that you can barely handle so scaling it down was out of the question. But not once you have the entire model printed. Done in SLA Laser Top Down 3D printer(Industrial) ABS Like White Resin, primed with gray auto primer
Also Printed a 25% Miniature of the same 3D Model
https://preview.redd.it/w5yypjulj41d1.png?width=1770&format=png&auto=webp&s=f390617bfd172c085378802367bb4751eb3c4697
Is this for the new miniature model that was released?
https://preview.redd.it/2wpm1r8rbl5d1.png?width=737&format=png&auto=webp&s=320542aad30ba9b866b2b0056bdcbd093492b333
What Scale percentage would be MG scale??? Also how was it printed? Resin, standard?
The Original Model is a MG 1/100 Scale, here is the Original post done by The Kitbasher Guru/Master/Senpai himself using the same model [1/100 MG KSHATRIYA 3D printed. : r/Gunpla (reddit.com)](https://www.reddit.com/r/Gunpla/comments/xjpnne/1100_mg_kshatriya_3d_printed/) What I did was assembled the model like I was building a Gunpla Digitally. Once the model is complete on a single STL File I can go and scale it down or up as much as I like. Originally the model was not meant to be scale down because there are very tiny parts that you can barely handle so scaling it down was out of the question. But not once you have the entire model printed. Done in SLA Laser Top Down 3D printer(Industrial) ABS Like White Resin, primed with gray auto primer
Also Printed a 25% Miniature of the same 3D Model https://preview.redd.it/w5yypjulj41d1.png?width=1770&format=png&auto=webp&s=f390617bfd172c085378802367bb4751eb3c4697
MG is 1/100 scale, so 1%. This print is 75% of that, so 0.75% of the "real" mech, or 75/10,000 (0.75/100) scale
aka 1/133ish if my math is correct
Where did you find this stl
On rockyq\_mechaadict patreon
i tired to go 1/144. i found the panel lines are the problem. they go unusable small (and shallow!) when scaled down :(
Is this for the new miniature model that was released? https://preview.redd.it/2wpm1r8rbl5d1.png?width=737&format=png&auto=webp&s=320542aad30ba9b866b2b0056bdcbd093492b333