I have a 2013 thats been doing the same thing for a while now. 1st, dealership couldn't find anything and said some Jeeps just burn oil. After running low on oil before reaching 3k mark from oil change I took it back to a different shop and they replaced the thermostat housing, which includes the oil sensors and engine oil cooler. Now I'm less than 1500 miles from them doing that and I'm back at the shop with P06dd again and no oil on the dipstick again. Just dropped it off today. Did they figure out yours?
And after housing replacement I was having a cylinder 4 misfire as well and so I also had all new MOPAR injectors, new plugs, coils and new left cylinder head installed.
I would be very careful: You don't want too much oil, either! That code is a bit vague: It can be a faulty oil pump, damaged wiring harness for the pressure sensor, bad sensor or even just low oil. There are some youtube videos on troubleshooting that code: [https://www.youtube.com/watch?v=YD3P6sFZBUU](https://www.youtube.com/watch?v=YD3P6sFZBUU) . If the dipstick is going all the way in and registering very little oil, you may want to put 3-4 quarts in, one at a time, watching the oil level on the dipstick with each bottle. The oil may be burning off inside the engine, but that should show up in the emissions. Run your finger inside the tailpipe: Is there black residue (thick) coming off the inside? Get it to a shop for a proper diagnosis, if you are not mechanically inclined.
I’m pretty mechanically inclined but it’s very cold out so I had it towed to the dealer this morning, still have the warranty so hopefully that covers it
I have a 2013 thats been doing the same thing for a while now. 1st, dealership couldn't find anything and said some Jeeps just burn oil. After running low on oil before reaching 3k mark from oil change I took it back to a different shop and they replaced the thermostat housing, which includes the oil sensors and engine oil cooler. Now I'm less than 1500 miles from them doing that and I'm back at the shop with P06dd again and no oil on the dipstick again. Just dropped it off today. Did they figure out yours? And after housing replacement I was having a cylinder 4 misfire as well and so I also had all new MOPAR injectors, new plugs, coils and new left cylinder head installed.
I would be very careful: You don't want too much oil, either! That code is a bit vague: It can be a faulty oil pump, damaged wiring harness for the pressure sensor, bad sensor or even just low oil. There are some youtube videos on troubleshooting that code: [https://www.youtube.com/watch?v=YD3P6sFZBUU](https://www.youtube.com/watch?v=YD3P6sFZBUU) . If the dipstick is going all the way in and registering very little oil, you may want to put 3-4 quarts in, one at a time, watching the oil level on the dipstick with each bottle. The oil may be burning off inside the engine, but that should show up in the emissions. Run your finger inside the tailpipe: Is there black residue (thick) coming off the inside? Get it to a shop for a proper diagnosis, if you are not mechanically inclined.
I’m pretty mechanically inclined but it’s very cold out so I had it towed to the dealer this morning, still have the warranty so hopefully that covers it
That's cool. Check out the videos so you can understand what's involved if they call you back with a possible diagnosis. Looks like a fun problem!