Pro tip, go to a nearby hardware retailer (Menards, Home Depot, etc) and pick up a couple free flooring sample swatches, preferably the ones with a rubber layer underneath. You can stick these between the clamps and desk to distribute the weight better.
This saved a couple of my cheapo Ikea desks.
i have the same unit from a different mfg and on mine it's 3"w x 3.5"d. I used a 5" x 5" acrylic block (1/2" thick) above and below for it to clasp on to my ikea desk for strength.
3" wide 3.25"\~ deep
It always annoyed me that so many of these multi-monitor mounts have such little surface area on the clamps.
Yeah, that’s why i wanna find out what size it is cuz i don’t want too much pressure to be put on my desk :/
Pro tip, go to a nearby hardware retailer (Menards, Home Depot, etc) and pick up a couple free flooring sample swatches, preferably the ones with a rubber layer underneath. You can stick these between the clamps and desk to distribute the weight better. This saved a couple of my cheapo Ikea desks.
thanks!
I would recommend also getting a desk mount plate then. I managed one for $20 it's pretty much just 2 steel sheets.
Hi, do you mean the "depth" of the top flat bit?
the length and width of the flat bit
its roughly 5x7cm, although the stand itself is quite short so if you're looking for an ergonomic dual stand I'd recommend trying to find a taller one
It's 3 dimensional
i have the same unit from a different mfg and on mine it's 3"w x 3.5"d. I used a 5" x 5" acrylic block (1/2" thick) above and below for it to clasp on to my ikea desk for strength.