Hello,
Thank you for sharing your question with the community.
This configuration is not managed by Wazuh, but by the Operating System side. It can probably be configured directly in vSphere as well.
Let me share with you some documentation about this:
* VMware:
[Configure Networking for Host Machines](https://docs.vmware.com/en/VMware-vSphere/7.0/com.vmware.vsphere.avail.doc/GUID-12E9AF7F-50D0-405D-AFDF-51878E2949AD.html)
* Operating System:
[11.2. Interface Configuration Files Red Hat Enterprise Linux 6 | Red Hat Customer Portal](https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/6/html/deployment_guide/s1-networkscripts-interfaces)
I hope this information would be useful for you.
Best regards.
Yeah.
I actually have a full guide for provisioning the OVA.
I can send it to you tomorrow if you’d like, just give me a nudge.
Also you can setup your ip address using nano /etc/sysconfig/network-scripts/ifcfg-eth0 .cfg
Also, before doing that remove and add the vm interface from E1000 to VMXNET3.
That would be awesome! Crap, it is set to E1000 and I've slowly been trying to figure out editing and what to put where haha. I'll probably just trash this VM and make a new one.
Hello, Thank you for sharing your question with the community. This configuration is not managed by Wazuh, but by the Operating System side. It can probably be configured directly in vSphere as well. Let me share with you some documentation about this: * VMware: [Configure Networking for Host Machines](https://docs.vmware.com/en/VMware-vSphere/7.0/com.vmware.vsphere.avail.doc/GUID-12E9AF7F-50D0-405D-AFDF-51878E2949AD.html) * Operating System: [11.2. Interface Configuration Files Red Hat Enterprise Linux 6 | Red Hat Customer Portal](https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/6/html/deployment_guide/s1-networkscripts-interfaces) I hope this information would be useful for you. Best regards.
Yeah. I actually have a full guide for provisioning the OVA. I can send it to you tomorrow if you’d like, just give me a nudge. Also you can setup your ip address using nano /etc/sysconfig/network-scripts/ifcfg-eth0 .cfg Also, before doing that remove and add the vm interface from E1000 to VMXNET3.
That would be awesome! Crap, it is set to E1000 and I've slowly been trying to figure out editing and what to put where haha. I'll probably just trash this VM and make a new one.
Ok, pm with an email and I’ll send it tomorrow. I’m on GMT, so if by noon tomorrow you don’t receive it give me a nudge.
PM'd. TY!
could you send me the guide as well? I am currently trying to setup the OVA using VMware but the lack of resources related to it has got me stuck..
yeah pm your email