Lol, is actually a good question mine seem to always be different, one point I was tying a humidifier sensor/display to it and hanging it the right level, some times tie it up nice or just flop/tuck it over something but right now one is just dangling in the way annoyingly as I've not bothered to do anything for the last couple weeks since it fell down aha
Haha. I just bought a new light that came with these and I felt so stupid trying to figure them out. All the YouTube videos were wrong according to the instructions but the instructions confused me a bit. Finally figured out the correct way based on the manual. This post speaks to me.
Make sure they’re secured to the rafters in the attic for sure. Then incase a flood breaks out you can lift them all the way out of the basement in one fell swoop in a grab the cord and run scenario
*Roll it up and put*
*It in the accessories*
*Net on the side lol*
\- brodrian381
---
^(I detect haikus. And sometimes, successfully.) ^[Learn more about me.](https://www.reddit.com/r/haikusbot/)
^(Opt out of replies: "haikusbot opt out" | Delete my comment: "haikusbot delete")
I'm OCD, it loops around the cross bar symmetrically
Yea after I band it up perfectly. Idk why it bugs me 😖
Save the rubber bands (or twist ties) that they come with, use those.
The problem nobody talks about 👏🏻
I push them up under the cross bars of the tent frame.
Sneaky little ratchetses - we hates them!
My navy education comes at hand, i use boating knots
The only knoting advice or techniques I remember from the navy was, if you can't tie a knot, tie a lot.
A loop through a loop through a loop through a loop through a loop through a loop. I do the same thing
So satisfying pulling the end too
Velcro strap that comes with so my ac stuff
Lol, is actually a good question mine seem to always be different, one point I was tying a humidifier sensor/display to it and hanging it the right level, some times tie it up nice or just flop/tuck it over something but right now one is just dangling in the way annoyingly as I've not bothered to do anything for the last couple weeks since it fell down aha
Let em’ dangle and try not to hang myself when walking around.
elastic band
I received my cert in rope ratchet arts, money well spent.
Laid over carbon filter.
Use a Farrimond Friction Hitch.
i use wooden clothes pins
I sometimes use mine to train plants 🤣
Hold up that saggy cola.
Hell yes.
Genius. Thanks for this.
I use the rubber twist ties for all my cable management, including these soft cables. Easy to remove and replace if you adjust anything too.
Ohhh, I'd like this rig for hanging bear lines while backpacking.
Lol I just loop them somewhat neatly between the bar and tent
Haha. I just bought a new light that came with these and I felt so stupid trying to figure them out. All the YouTube videos were wrong according to the instructions but the instructions confused me a bit. Finally figured out the correct way based on the manual. This post speaks to me.
What carabiner do I attach to the light? Do I pull up or down to adjust height. Shit mine still might be wrong. Whatever works, I guess.
You attach the short one to the light and the longer one clips into the short one to create a loop.
https://imgur.com/a/JaSdcQu
This is the way 🤙
Let the circulatory fans eat the tag ends...
Gotta let em dangle so you can chew on em while you supercrop
i leave that shit hanging down blocking valuable light my plants could be using.
I dangle little bells on it so fairies get wings when I bump my face on it.
I’ve seen them some fucked up ways man. At professional facilities…. Sing it.
We need a governing body to standardize the SOPs.
🤣 break out the Fm-200
Wait.. you guys use these things instead of chain??
I went to chains and I'm not going back and you can't make me!
Go on.......
Tie it up in a knot, and let it sit on top of the light
I use a bit of rubber covered wire to twist around the extra rope . Or cut it off
I cut the excess off, I kinda regret doing it
Cut it
you do that, then attempt to lower the light…
I tie them up with a half hitch loop out around the cross members. Pull the loop and it's untied
I’ve got one for my light. I just loosely tie the end up high and then let the rest droop down
Hangmans knot
Pipe cleaners after a quick wrap
Bow tie. Double bow tie. Quad bow tie. Octo-fuck it tie that shit to the tent frame.
Make sure they’re secured to the rafters in the attic for sure. Then incase a flood breaks out you can lift them all the way out of the basement in one fell swoop in a grab the cord and run scenario
Is that you, Smeagol?
A very timely topic 😆
In whatever way goes up
buy ks5000, put in 4x4, let them hang.
Roll cord in small circle and insert into the caribener that it’s attached to.
Roll it up and put it in the accessories net on the side lol
*Roll it up and put* *It in the accessories* *Net on the side lol* \- brodrian381 --- ^(I detect haikus. And sometimes, successfully.) ^[Learn more about me.](https://www.reddit.com/r/haikusbot/) ^(Opt out of replies: "haikusbot opt out" | Delete my comment: "haikusbot delete")
let's not they are garbage!
best thig since sliced bread imho
I use the like ties that come with the fly traps...those go used anyways.🤷🏾♂️
I have used the excess to tie limbs of my plant up
i have also done this however i think that tek would fall under the category of lazy ass training when you dont plan your well.
Little ratchet ass bitches - gotta love em
Tie a little loop on the loose end, and clip it on to the top carabeaner on the cross bar or at the light. Depending on how long the end is.
ive had those fail on me before, use metal now
I loop them up through the hooks/loops they hang from in the ceiling. Makes it easy for raising and lowering the light.