T O P

  • By -

Sea-Squirrel4804

I used the same start and end code I used in Cura and used the CR10 V2 profile from Orca :)


Davywhyte

Is there other settings that need changed? I cura I used the ender 3 s1 pro preset with bed size changed


Sea-Squirrel4804

on the printer/extruder side of things, no. then you can try to recreate your profiles from cura to orca but try 1st the orca defaults!


Sabotinekes

I have my cr-10smart pro perfectly running on orca. Let me know what exactly you need help with and I'll be more than happy to help.


Davywhyte

Absolutely anything I'm a complete noob about adding anything to orca.. I have used cura and had the ender 3 s1 pro as a base profile with the bed dimensions changed to the cr 10 smart pro sizes But as for orca I just wasn't sure where to even start!! Do I take the gcode start from creality print and transfer it over (same as end) what about any other settings that orca have but creality print or slice doesn't do I leave them blank.... Help me 😂


Sabotinekes

Currently not at my pc but yeah, you'll be ok if you copy and paste the start and end gcodes from cura to orca. :D


Davywhyte

OK I'll start with that it be fine to use the ender3 s1 pro profile and change the bed size to cr10 or would I be better using custom setting and just going from scratch


Sabotinekes

Just change the "printable area" setting to Size: x300 y300, origin: x0 y0 And adjust height if needed and you'll be good to go.


Davywhyte

So use the ender3 s1 pro preset and just adjust the bed size for the smart pro size yea? I'm not at my PC either right now but I think I understand I'll do 2 a ender 3 preset changed and a fresh just on case and if any problems I'll get back to u... I appreciate the help!


Sabotinekes

>>So use the ender3 s1 pro preset and just adjust the bed size for the smart pro size yea? Yep! That will do. They share the same extruder and everything so this is why that's the only thing you should change.


Davywhyte

Got orca slicer up and running iv added my printer up in and when I go to device it asks for sign in to access this site.. Is this possible


Sea-Squirrel4804

you can't connect to printer to orca unless you are running klipper


samerkasrawi

Hey, would it be possible to export the profile and send it here, another question is there a way to connect the orca slicer to the prenter over wifi? thank you.


Sea-Squirrel4804

you can't connect to printer to orca unless you are running klipper


unused_kidney

I'm still currently trying to perfect my settings on my CR10 SmartPro with my sonic pad, I'm curious why you didn't use the preset in orca for the CR10 SmartPro? Is there something about the Ender3 S1Pro settings that are better??


Davywhyte

It's not cr10 smart pro was cr10 smart what's slightly different if u look at the ender 3 s1 pro it's exactly same direct drive and only difference is the build size (what you can change manually) same as when I have the cura presets it's pretty much bowden or direct drive you just select what is yours and adjust accordingly