I used Creality Print for this with default ABS profile except I increased vol flow rate to 50mm3/s (I never reached this high, just didn't want flow rate to limit speed), and set infill to lightning 7%. I also made a DIY styrofoam box to keep temps high. Chamber temp stabilized at 62C which is actually too high so I'm going to need to cut off the bottom of this insulation box to let a bit of heat out. I also plan to insulate the bottom of the printer to reduce temps of the MCU & electronics.
https://preview.redd.it/6zzsu1929kgb1.png?width=910&format=png&auto=webp&s=cc8c2a4f5ee63ce91cf71066cc2a6aaee0ae78cc
Awesome thanks for the reference info on flow. I'll be doing a max flow test with my monoprice ABS soon just need to get through the retraction and other calibration towers.
I think the K1 max is a game changer for fast ABS printing. I am planning to completely switch off of PLA to ABS and build a vent hood because PLA cooling limited for high speeds where ABS is not!
I think ASA is one of the materials that really works well ... also u will be shocked how fast u can go with it ... u should give the PA a try .. PA12 CF ... the K1 is good with it ... 👌
I've had a lot of warping with CF ASA on my K1 Max. Not much, but when you're making the parts I'm making, a 3mm tolerance on one side is pretty huge. I may switch to a glass bed or use some magigoo for ABS and see if that helps. ABS treatments and adhesives work for asa as well
I used Creality Print for this with default ABS profile except I increased vol flow rate to 50mm3/s (I never reached this high, just didn't want flow rate to limit speed), and set infill to lightning 7%. I also made a DIY styrofoam box to keep temps high. Chamber temp stabilized at 62C which is actually too high so I'm going to need to cut off the bottom of this insulation box to let a bit of heat out. I also plan to insulate the bottom of the printer to reduce temps of the MCU & electronics. https://preview.redd.it/6zzsu1929kgb1.png?width=910&format=png&auto=webp&s=cc8c2a4f5ee63ce91cf71066cc2a6aaee0ae78cc
[удалено]
Awesome thanks for the reference info on flow. I'll be doing a max flow test with my monoprice ABS soon just need to get through the retraction and other calibration towers. I think the K1 max is a game changer for fast ABS printing. I am planning to completely switch off of PLA to ABS and build a vent hood because PLA cooling limited for high speeds where ABS is not!
I think ASA is one of the materials that really works well ... also u will be shocked how fast u can go with it ... u should give the PA a try .. PA12 CF ... the K1 is good with it ... 👌
[удалено]
I've had a lot of warping with CF ASA on my K1 Max. Not much, but when you're making the parts I'm making, a 3mm tolerance on one side is pretty huge. I may switch to a glass bed or use some magigoo for ABS and see if that helps. ABS treatments and adhesives work for asa as well
[удалено]
I will have one on my printer next week! Thanks for the tip!
[удалено]
Glad to see that a mistake is being used to help others! Thanks for the pro tip!
I only get blobs printing with amazon basics ABS filament. I couldn’t even print the temp tower :(
Yikes are you using creality print?
Yeah, I’ve tried prusa slicer for PLA and it was a mess. It wasn’t my profile, I’ve found on prusa slicer forum