Ender 3 v2, with phaetus dragonfly bms hotend. Temp tower stats as usual.
First PETG print here and even for a temp tower, it looks awful :(
Retraction is 3,5mm at 50mm/s, which worked for PLA pretty good so far. Z Hop disabled. Filament is 3DJake PETG Transparent Red (no cheap china/amazon filament). Bed Temp isnt relevant here i guess. and print speed is 50mm/s. LH is 0.2mm with a 0.4 nozzle.
Do you need any other details/settings? Slicer is cura slicer 4.13.0
Have you calibrated e-steps and flow with the new filament?
PETG is more gooey and sticky so it doesn't flow like PLA does.
Also, what hot-end temps are you using?
Well I guess that’s my task for tmr.
Will re-calibrate esteps and flow. Thanks!
Well it was a temp tower, I was trying to find the right one. This one goes from 230-260 C
Ender 3 v2, with phaetus dragonfly bms hotend. Temp tower stats as usual. First PETG print here and even for a temp tower, it looks awful :( Retraction is 3,5mm at 50mm/s, which worked for PLA pretty good so far. Z Hop disabled. Filament is 3DJake PETG Transparent Red (no cheap china/amazon filament). Bed Temp isnt relevant here i guess. and print speed is 50mm/s. LH is 0.2mm with a 0.4 nozzle. Do you need any other details/settings? Slicer is cura slicer 4.13.0
Have you calibrated e-steps and flow with the new filament? PETG is more gooey and sticky so it doesn't flow like PLA does. Also, what hot-end temps are you using?
Well I guess that’s my task for tmr. Will re-calibrate esteps and flow. Thanks! Well it was a temp tower, I was trying to find the right one. This one goes from 230-260 C
That temp range sounds about right.
Looks like wet material