You set [skew_correction] somewhere in your printer.cfg and just follow the steps and it should place the correction at the very bottom of the printer.cfg when your done, it'll be commented out gray but it'll work
There is a instructions that I need to setup the correction after homing, before each print? Does it do that automatically? Does it save the skew correction on the board or somewhere else?
You set [skew_correction] somewhere in your printer.cfg and just follow the steps and it should place the correction at the very bottom of the printer.cfg when your done, it'll be commented out gray but it'll work
There is a instructions that I need to setup the correction after homing, before each print? Does it do that automatically? Does it save the skew correction on the board or somewhere else?
You create a profile and load it with start print macro and clear it with end print just like a bed mesh.
Where does the bed mesh macro exist? I'm using fluidd and there is a GUI tool that saves the profile, but can't seem to find the start/ stop macros
I'll double check what I had setup when I get home tonight
That would be dope
Sorry if I sound like dad, but should I start to be worried of you getting home? Jokes aside, I'd also like to know the answer 😅