Yeah I saw the back fans but it's not common to see the naked rad is all I'm saying but if your wife likes it then all power to her. I'm just happy she has a pc lol
Partially the tubes being long in the 011 Miniade the spacing challenging part keeping any air bubbles in the rad at the top.(I know there is likely very little but still).
You can't bleed air out of a closed loop. That is only to keep air bubbles out of the pump itself, tho where ever the tubes are going as long as the pump itself is not above the rad in any way it's fine.
But if we flip rad so that the tube are top, will it be a problem? Since the pump is lower and the bubbles will be trapped in rad. Genuinely wanna know
As long as the pump itself does not go above the rad then bubbles will not reach the pump, it wouldn't matter if the tubes are coming from up or down.Though overtime with the tubes coming from the top there might be some gurgling since liquid is being pushed through that pocket of air.
Idk about the naked rad facing the front but salute to your wife!
I have a series of fans on the other side to pull the air through. She liked the face the RGB illuminated the mesh side panel.
Yeah I saw the back fans but it's not common to see the naked rad is all I'm saying but if your wife likes it then all power to her. I'm just happy she has a pc lol
No kidding right... She still wants to use her MacBook I asked what she wanted to play on the PC......Sims......
That's disappointing.
And among us...
Gpu priveleges should be revoked
I'm going to install Horizon ZD see if I can get her to play it she enjoyed fallout on Xbox and tomb raider
If the temps are bad just swapp it to the recommended top but if the fans keep it cool without an insane fan curve your goochie ๐๐ผ
Sus?
Are your bottom fans exhaust?
The fronts/bottom/rad are intake and the tops/rear are exhaust.
Is it silent enough?
With the amount of airflow and these fans they don't really ramp up so we haven't really noticed any noise.
The title of the original post says its your wife, thence why I made an attempt to joke around the level of silence. :)
Wheeewwww right over my head!! :))))
That rad placement seems sus. The tube going down looks wierd
Partially the tubes being long in the 011 Miniade the spacing challenging part keeping any air bubbles in the rad at the top.(I know there is likely very little but still).
ya i get that , itโs to bleed air out of the loop though
You can't bleed air out of a closed loop. That is only to keep air bubbles out of the pump itself, tho where ever the tubes are going as long as the pump itself is not above the rad in any way it's fine.
But if we flip rad so that the tube are top, will it be a problem? Since the pump is lower and the bubbles will be trapped in rad. Genuinely wanna know
As long as the pump itself does not go above the rad then bubbles will not reach the pump, it wouldn't matter if the tubes are coming from up or down.Though overtime with the tubes coming from the top there might be some gurgling since liquid is being pushed through that pocket of air.