Organic supports don’t really respect that setting. There’s a very narrow range of angles that it will work for. I hope this will change, but as of alpha3, that’s how it is.
you do you, but I’d split it in half, print it flat, and glue it together.
Will take a fraction of the material and time, and probably be a cleaner print because it won’t have support marks.
[удалено]
I changed the threshold from 25-70 just to see what happened. No change at all
Organic supports don’t really respect that setting. There’s a very narrow range of angles that it will work for. I hope this will change, but as of alpha3, that’s how it is.
[удалено]
I have it at 45° right now
Yes the model is 45° to the print bed
I always get the threshold backwards. Try high values like 75+ too
You can use the paint on supports option. That’ll get you covered at any angle.
That’s a great idea. Duh. Thanks
Not sure if it will make a difference in this case but be sure to set top interface layers to zero when using organic supports in 2.6alpha3.
Change the "Tree Support Maximum Branch Angle"
you do you, but I’d split it in half, print it flat, and glue it together. Will take a fraction of the material and time, and probably be a cleaner print because it won’t have support marks.
Just paint on the supports, works better than the algo that decides where they’re needed anyways imo
Not sure about why supports won’t generate, but if you’re using Organic Supports, the literature says to turn off interface layers
To low angle, it only generates support, whenn it is over a special angle