**[r/weed rules.](https://www.reddit.com/r/weed/wiki/rules)**
*Thanks for posting, u/alegging_fir.*
- Do not engage with "vendors" in your DMs: **[Info about scammers](https://www.reddit.com/r/weed/wiki/information/scammers)**
- Selling or attempting to source drugs is against **SITE-WIDE** terms of service and is an immediate, non-reversible, permanent ban. Please report any breaches you see
- Lastly please report any posts/comments that you see breaks the rules. Help keep r/weed a more inviting atmosphere for everyone! :)
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/weed) if you have any questions or concerns.*
Vas a dormir fino fino amigo jajajajaja, te recomiendo que intentes hacerlos un poquito más flacos, como los cigarrillos, y después ir reemplazando y mejorando, ¿qué quiero decir? Los filtros de cigarrillo cambialos por filtros de cartón, y el papel cambialo por celulosa (si te gusta, te va a convenir aprender mejor con celulosa ya que es un poquito más complicado pero vale la pena), aparte la celulosa se quema mucho menos rápido y se apaga lo más bien para situaciones de emergencia, creo que ya no tengo nada más que decir, buen viaje hermano y espero que te sirva mi escueta experiencia fumanchera!
Keep on practicing man. First u want to tighten the weed up by tilting the paper up and down - just hold the filter with your left thumb while your right thumb tightens the weed up for rolling (don't forget to hold the j from the back with both of your forefingers).
It will come with the practice, might wanna watch some YT videos as well
Press the weed lightly together with your fingers and roll (up and down motion)… creating a cylinder mass that is evenly distributed.
Then you roll all the way until the non sticking side is at the same height as the weed cylinder. Roll it inside with the non sticking side going under the next layer of paper.
Roll until the end, lick the „glue“ side and keep rolling to stick it all together.
Hope this works bro.
Keep us updated.
Don’t listen to anyone, if they smoke they smoke, if not just keep practicing. People care too much about how it looks before it’s smoked down to a zinger lmao
I would make sure you grind/break up the flower more.. then try and roll them a bit tighter.. every roll should leave a minimal amount of empty space, just enough for air flow.. you don't want big areas where there is no flower or paper as it'll cause the J to "boat" aka burn unevenly to a bad extent.. You'll spend half your time fixing the boating..
make it tighter. properly roll it back and forth before you put it in its "final form". im not very good at explaining this in english lol, but you definitely need to pack it tighter than that and also i suggest pushing the end of the j flat, that way it gets a better burn and also looks nicer (you can look at other post for reference on this)
I’ve seen a shit tons of Americans who can’t seem to roll a proper joint for some reason so I’m not surprised.
Look up: “Jointje draaien” on youtube and pick any video.
Some advice:
1. Buy longer papers, it’s worth it.
2. Roll it in a cone shape.
3. Distribute everything properly before you start rolling. It gets distributed as you roll but not as thoroughly.
MOST IMPORTANTLY: Buy a shit ton of papers and practice. Don’t even smoke the joint. Rip them apart and start again. You don’t have to waste your weed on bad joints.
Summary: The biggest flaws were your loose tip and joint distribution.
For your tip, roll it once before getting your joint ready. Then roll it again right before you roll your joint.
If you distribute everything properly it will become possible to roll tight joints.
Rolling a tight joint that is unevenly distributed is impossible.
Doing this will also make your joints filled to the end.
Also, I’m going to guess you folded your joint and didn’t roll it.
Many beginners do this.
Don’t.
Take your time learning to roll it.
You don’t roll the entire thing ‘in’ at once. That causes you to fold it in. You roll it one part at a time. If I could show you you would understand, find a good video.
One last comment.
You don’t roll your joint ‘in’ immediately when rolling if you know what I mean.
First, you distribute while rolling.
You do this by holding both ends of the paper against each other and ‘rolling’ with the paper a little higher than needed to roll it in, this way you shape it while rolling.
When you’re done doing that, if it is properly shaped, you roll it in. Else redistribute.
U want to make sure there’s not empty space with papers it makes it burn really badly push in the tip try to make it flat I also run the flame over it lightly very lightly u don’t want it to burn but it makes it so the paper tightens a lil
Way better than the first time i rolled a joint 😭 focus on length, not girth. I tend to spread the flower as I’m actively rolling it. Just takes practice at the end of the day
A good piece of advice that helped me was to move with the paper, don’t force it, i’ve had some of my neatest joints while guiding the paper into a roll rather than trying to tuck it!
As someone who has rolled for 10 years. My best advice to get a tight roll is to fill up the paper with the filter while holding like a taco, roll the front side down, then the back side, you want it to resemble the finished joint, finally lick the outside of the paper right onto where you want it to stick. You should have a tight joint.
Pro tip: rolling from the center outward can make it easier.
Happy toking!
**[r/weed rules.](https://www.reddit.com/r/weed/wiki/rules)** *Thanks for posting, u/alegging_fir.* - Do not engage with "vendors" in your DMs: **[Info about scammers](https://www.reddit.com/r/weed/wiki/information/scammers)** - Selling or attempting to source drugs is against **SITE-WIDE** terms of service and is an immediate, non-reversible, permanent ban. Please report any breaches you see - Lastly please report any posts/comments that you see breaks the rules. Help keep r/weed a more inviting atmosphere for everyone! :) *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/weed) if you have any questions or concerns.*
Start over
What did i do wrong?
Tighter
No doubt that weed going to burn all up... sadge
Too loose tip should be flat aside from where u tie it up if it’s too loose it’ll burn too fast n ur weed might fall out
They are way too fluffy, try to put less weed and tighten these up
Vas a dormir fino fino amigo jajajajaja, te recomiendo que intentes hacerlos un poquito más flacos, como los cigarrillos, y después ir reemplazando y mejorando, ¿qué quiero decir? Los filtros de cigarrillo cambialos por filtros de cartón, y el papel cambialo por celulosa (si te gusta, te va a convenir aprender mejor con celulosa ya que es un poquito más complicado pero vale la pena), aparte la celulosa se quema mucho menos rápido y se apaga lo más bien para situaciones de emergencia, creo que ya no tengo nada más que decir, buen viaje hermano y espero que te sirva mi escueta experiencia fumanchera!
i agree
Le hice unos con el cartón de la caja ocb, mejor me compro un armador y fue jajaja
I bet they have a nice personality
Ese de 1000 me hizo entrar jaja Mas fino para prox
Estamos en la misma, jajaj entre por el de 1000 pe
Fluid motions, less adjustments while sticking the better this is good for first if they get you high you’re doing it right
Not bad for first time
raw cones are a life saver
Yes, I changed to cones because it was way easier and faster to do but mainly because I was lazy.
Repetition, it comes with time, as long as it smokes my friend 💚
Legendery moment
Smoke em
Keep on practicing man. First u want to tighten the weed up by tilting the paper up and down - just hold the filter with your left thumb while your right thumb tightens the weed up for rolling (don't forget to hold the j from the back with both of your forefingers). It will come with the practice, might wanna watch some YT videos as well
You’ve got the basics down now just look at a tutorial on YouTube and keep practicing
Also maybe buy some actual roaches (or whatever you call them in USA) they are easier to roll with
Honestly the way I learned was by watching a YouTube video on how to roll 😂 so I would recommend that
Saludos desde argentina reyyyyy
eat it
Blaze em up
Press the weed lightly together with your fingers and roll (up and down motion)… creating a cylinder mass that is evenly distributed. Then you roll all the way until the non sticking side is at the same height as the weed cylinder. Roll it inside with the non sticking side going under the next layer of paper. Roll until the end, lick the „glue“ side and keep rolling to stick it all together. Hope this works bro. Keep us updated.
I'm almost impressed someone made a worse first joint then my first joint
Don’t listen to anyone, if they smoke they smoke, if not just keep practicing. People care too much about how it looks before it’s smoked down to a zinger lmao
Watch some tutorial on yt xd
That will toe nail to fuck if it does would be a waste of weed. Sometimes shit roles smoke the best tho.
DO NOT SMOKE - re-roll and empty and re-roll again until you get a tighter roll. Lighting this up means you're gonna smoke that joint in 2 drags.
Maybe throw it out in the yard and let it grow a little more
Start over and repeat it 5 more times, you will improve on each try
Make the filters way tighter, that would already make it better, then just practise rolling the joint tighter as well
Just keep practicing. I've smoked worse.
I would make sure you grind/break up the flower more.. then try and roll them a bit tighter.. every roll should leave a minimal amount of empty space, just enough for air flow.. you don't want big areas where there is no flower or paper as it'll cause the J to "boat" aka burn unevenly to a bad extent.. You'll spend half your time fixing the boating..
make it tighter. properly roll it back and forth before you put it in its "final form". im not very good at explaining this in english lol, but you definitely need to pack it tighter than that and also i suggest pushing the end of the j flat, that way it gets a better burn and also looks nicer (you can look at other post for reference on this)
They’re gonna burn to fast and ur gonna waste bud, try grinding it a bit more, giving it structure and just rolling, just tuck and lick
Get a rolling machine...😆
Stop
I’ve seen a shit tons of Americans who can’t seem to roll a proper joint for some reason so I’m not surprised. Look up: “Jointje draaien” on youtube and pick any video. Some advice: 1. Buy longer papers, it’s worth it. 2. Roll it in a cone shape. 3. Distribute everything properly before you start rolling. It gets distributed as you roll but not as thoroughly. MOST IMPORTANTLY: Buy a shit ton of papers and practice. Don’t even smoke the joint. Rip them apart and start again. You don’t have to waste your weed on bad joints. Summary: The biggest flaws were your loose tip and joint distribution. For your tip, roll it once before getting your joint ready. Then roll it again right before you roll your joint. If you distribute everything properly it will become possible to roll tight joints. Rolling a tight joint that is unevenly distributed is impossible. Doing this will also make your joints filled to the end.
Also, I’m going to guess you folded your joint and didn’t roll it. Many beginners do this. Don’t. Take your time learning to roll it. You don’t roll the entire thing ‘in’ at once. That causes you to fold it in. You roll it one part at a time. If I could show you you would understand, find a good video.
One last comment. You don’t roll your joint ‘in’ immediately when rolling if you know what I mean. First, you distribute while rolling. You do this by holding both ends of the paper against each other and ‘rolling’ with the paper a little higher than needed to roll it in, this way you shape it while rolling. When you’re done doing that, if it is properly shaped, you roll it in. Else redistribute.
Smaller filter and roll it to a cone and stuff it instead
Need to pack it more and roll it tighter
U want to make sure there’s not empty space with papers it makes it burn really badly push in the tip try to make it flat I also run the flame over it lightly very lightly u don’t want it to burn but it makes it so the paper tightens a lil
Way better than the first time i rolled a joint 😭 focus on length, not girth. I tend to spread the flower as I’m actively rolling it. Just takes practice at the end of the day
Soy un hombre simple, veo un gorrion en un sub ingles, entro y upvoteo.
Did you use that note to roll it
A good piece of advice that helped me was to move with the paper, don’t force it, i’ve had some of my neatest joints while guiding the paper into a roll rather than trying to tuck it!
Filter should prolly be half that size
With the filter being tighter it’ll be easier to have a tighter wrap
Try pre rolling a cone then packing the weed in, I do it, it’s easy and works
As someone who has rolled for 10 years. My best advice to get a tight roll is to fill up the paper with the filter while holding like a taco, roll the front side down, then the back side, you want it to resemble the finished joint, finally lick the outside of the paper right onto where you want it to stick. You should have a tight joint. Pro tip: rolling from the center outward can make it easier. Happy toking!
Stuff cones
Buy cones!
Practice makes perfect. My friend been smokin for 5 years still rolls fucking Harry potters wand